Backlight photo

Viewing 1 reply thread
  • Author
    Posts
    • #96498
      James Young
      Guest

      Man, am I going to have a difficult time articulating and getting all the details right. LOL

      Essentially, this:
      Panel

      I want to have a board with a square hole centered in the middle which will be covered by a photo. I tested it, and it does backlight well.

      Do you think I should prefill that hole, let it partially cure or fully cure, and then place the photo over it and finish the pour? Or put something like plexiglass under the photo and pour it all at once?

      Also, I will be backlighting with LED strips. If I put them in the epoxy I’m a bit concerned about heat and the fact that I won’t be able to change them if there is a failure.

      Thanks and regards,

      Jim

    • #96590
      Katherine Swift
      Keymaster

      Hi Jim,

      Thanks for the picture, but I’m not entirely clear on what you want to do.

      How do you want to use resin in this project?

Viewing 1 reply thread
  • The topic ‘Backlight photo’ is closed to new replies.
Subscribe to blog updates
Follow on Pinterest
Follow on Pinterest
Follow on Pinterest
Follow on Instagram
Follow on Youtube
Follow on Youtube