Resin casting stuck to table

Viewing 3 reply threads
  • Author
    Posts
    • #16051
      Katherine Swift
      Keymaster

      This question comes from Susan:

      I recently took a piece I made from it’s mold & set it on my dining room table. Evidently the bottom was still a bit tacky and now it is stuck! LOL Any ideas how I can get it off, I have tried prying it and it is stuck on there good.

    • #16052
      Katherine Swift
      Keymaster

      Hi Susan,

      I’m sorry to hear this happened to you. How frustrating!

      At this point, you need to go into it with the idea that something is likely to be ruined – your table or casting or both.

      Try adding boiling water or a heat gun to the base of your casting where it meets the table. The idea is to soften it up to allow you to use something like a screwdriver or paint scraper to get underneath the resin and lift it up. It may take five to ten minutes of ‘heat’ exposure to get it soft enough to lift up.

      Good luck!

    • #16054
      Susan
      Guest

      Thank you! I am hoping it is just the cast that gets ruined. I will let you know how it works!

    • #18435
      Aya
      Guest

      I had some resin stuck on a table and the hot water trick worked!

Viewing 3 reply threads
  • The topic ‘Resin casting stuck to table’ is closed to new replies.
Subscribe to blog updates
Follow on Pinterest
Follow on Pinterest
Follow on Pinterest
Follow on Instagram
Follow on Youtube
Follow on Youtube