[Madison]

Hi,
So i just poured some resin into a mold and then went to sent my molds in a warm water bath to help rid the resin of any lingering air bubbles. I filled he water a little to high in the bin so when i placed my mold in it water got on the surface of my resin (the actual piece is surrounded by the mold the pouring hole, an area i usually sand off in the end, is what got water on it) will this mess up my piece?

Thank you for any advice or help!

[Katherine Swift]

Yes, unfortunately, it’s going to mess up your casting. Resin hates water. Your piece is likely to cure sticky, if it cures at all.

[Author]

Posts