[rob]

After a flat pour,shallow 3/16 inch,over a 48×30 area ,I have a few small areas on the surface that are not curing.Is anyone familiar with this condition…can recommend a fix?
Thanks
Rob

[Katherine Swift]

Hi Rob,

This is likely from unmixed resin in your cup. This usually happens when you scrape out the last little bit of resin in your cup. This resin isn’t mixed as well as the resin that gets poured out first. If the resin is simply sticky (and not gooey), another layer of resin across the entire surface will fix it.

[Katherine Swift]

This article explains how to mix sticky resin: https://www.resinobsession.com/resin-frequently-asked-questions/how-to-fix-sticky-resin/

[Author]

Posts